Should you receive a "System not initialized yet" error when you access the Power Agent webserver, there are two reasons for this message.

Scripting is not enabled on the Power Agent. Check if Scripting is enabled using the following Power Agent webpage (replace 'ip_address' for your configure Power Agent's IP Address): http://ip_address/config/info.ehtml
Look for the line: Enabled Features: Scripting

If this feature is not visible, send us an email with your MAC Address. If you have the key to enable the Scripting feature insert it on the following Power Agent webpage (replace 'ip_address' for your configure Power Agent's IP Address): http://ip_address/CGI/mParseCGI?file=options.html



The other fault is linked to no valid IP Address being configured in the Power Agent script. Fix this using the following steps:

• Launch EtherPAD Explorer, and scan for the Power Agent.
• Highlight the Power Agent and 'Set IP address'.
• Physically recycle power to the unit. If you access the PowerAgent without rebooting you receive " System not initialized yet ".
• Launch browser via EtherPAD Explorer's 'Web configuration' or inserting the IP Address in the browser URL bar.
• You should get the Power Agent configuration page.
• (optional). Use http://ip_address/user/selector.san?reset=2 to reset the configuration mode.